Curing Technology

Exploring the: Curing Technology Zone

6 Results for: Case Study

Sort by:
Published: 9/27/2017

Fraunhofer ICT in-mold pressure sensors for HP-RTM
Pressure sensor-based mold fill expected to maximize part consistency and minimize cycle time for auto industry molders.

Published: 11/23/2016

Size-unlimited OOA composite process enables next-gen system
United Launch Alliance selects Ruag Space for lower cost/improved quality out-of-autoclave manufacture of Vulcan’s composite primary structures.

Published: 5/9/2016

Thermoplastic composite wings on the horizon?
OUTCOME, a project under the Clean Sky 2 program, aims to industrialize out-of-autoclave thermoplastic primary aerostructure.

Published: 6/1/2015

Out-of-autoclave processing: <1% void content?
Research sheds light on air and air-bubble behavior in OOA aerospace prepregs.

Published: 5/2/2011

Microwave: An alternative to the autoclave?
Aerospace composites manufacturer GKN evaluates microwave oven practicality and cost-effectiveness.

Published: 2/5/2010

A400M cargo door: Out of the autoclave
This structural military airframe part is the largest made to date via the vacuum-assisted resin infusion process.