Curing Technology

Exploring the: Curing Technology Zone

61 Results for: Article

Sort by:
Published: 6/5/2018

SAMPE 2018 keynote looks to the composites future
The SAMPE 2018 general session featured the announcement of the top three papers presented at the conference, and a keynote by Carmelo Lo Faro, president, Solvay Composite Materials (Alpharetta, FA, US).

Published: 2/27/2018

Consolidating thermoplastic composite aerostructures in place, Part 2
Thermoplastic composite structures could eliminate the autoclave and fasteners, but will a one- or two-step process prevail?

Published: 7/25/2017

CAMX 2017 preview: TenCate Advanced Composites
TenCate Advanced Composites (Morgan Hill, CA, US) is highlighting new thermoplastic and thermoset prepreg technologies. 

Published: 7/23/2017

CAMX 2017 preview: Epcon Industrial Systems
Epcon Industrial Systems (The Woodlands, TX, US) is featuring its industrial ovens and furnaces for curing, paint finishing, burn-out, heat treating, annealing and aging.

Published: 7/22/2017

CAMX 2017 preview: Dixie Chemical
Dixie Chemical (Pasadena, TX, US), a producer of epoxy curing agents and specialty chemicals for the thermoset and composite markets, offers a range of anhydride curing agents, reactive diluents, tougheners, resins and bio-based raw materials.

Published: 6/28/2017

Unweighting a crane to increase payload limit
Rethinking a crane stinger with carbon fiber for a more “uplifting experience.”

Published: 4/11/2017

Ceramic matrix composites: Hot engine solution
Disruptive designs for composites operation in 1093°C zones.

Published: 1/31/2017

JEC World 2017 exhibit preview
JEC World will be held March 14-16 in Paris. CW previews some of the products and technologies that will be at the show.

Published: 1/23/2017

OOA composites in next-generation launch systems
As United Launch Alliance ULA replaces Atlas and Delta with next-generation launch rockets under the Vulcan name, supplier Ruag Space has been selected to provide lower cost/improved quality out-of-autoclave fabrication of Vulcan’s composite p...

Published: 10/20/2016

CAMX 2016 Show Report
The 3rd annual joint ACMA/SAMPE-sponsored trade event comes to Anaheim with an exhibition and conference program attractive to professionals across the composites world.