BASF develops particle foam based on polyethersulfone
New foam is characterized by high-temperature resistance, inherent flame retardancy and light weight coupled with good stiffness and strength.
BASF (Ludwigshafen, Germany) announced Sept. 19 it has developed prototypes of the world’s first particle foam based on polyethersulfone (PESU). The foam is characterized by high-temperature resistance, inherent flame retardancy and light weight coupled with great stiffness and strength.
According to BASF, Ultrason E, is an amorphous thermoplastic with a high glass transition temperature of 225°C and remains dimensionally stable up to this temperature. Foams made of Ultrason E are approved for use in aircraft. The material, with its high limiting oxygen index of 38 (according to ASTM D 2863), meets the requirements for commercial aircraft with regard to combustibility, low heat release and low smoke density (“fire, smoke, toxicity”) without the addition of flame retardants. The expandable PESU granulate is pre-foamed into beads with low densities between 40 and 120 g/L and can be processed into molded parts with complex 3D geometries.
Despite its low density, the PESU particle foam thus enables stiff and strong components with good dimensional stability at high temperatures. According to BASF it is well suited for complex-shaped components in cars, airplanes and trains, which must be able to withstand high operating temperatures and meet stringent flame-retardant requirements.
Related Content
-
Sustainable, inline recycling of carbon fiber
Shocker Composites and R&M International are developing a supply chain for recycled CF with zero knockdown vs. virgin fiber, lower cost and, eventually, lengths delivering structural properties close to continuous fiber.
-
Materials & Processes: Fabrication methods
There are numerous methods for fabricating composite components. Selection of a method for a particular part, therefore, will depend on the materials, the part design and end-use or application. Here's a guide to selection.
-
Wet compression molding
Automated process cuts cycle time and cost for CFRP parts with potential for 65% fiber volume via Dynamic Fluid Compression Molding variant.