Results: 1 to 10 of 44

Sort By: Posted Date | Source

Type: AllArticleCase Study

Solvent-free release a good match for wind blade molding
5/21/2009

Lightweight, stable large-tool concept requires no master model
4/24/2009

After two years of testing, partners Advanced Composites Group (ACG, Tulsa, Okla.) and GrafTech (Parma, Ohio) are commercializing the ACG GRAFOAM FPA-20 tooling system, a new concept in dimensionally stable, low-mass, high-temperature-compatible composite tooling. The system’s foundation is carbon foam.

Tooling
1/8/2009

The molds used for forming composites, also known as tools, can be made from virtually any material. For parts cured at ambient or low temperature, or for prototyping, where tight control of dimensional accuracy isn’t required, materials such as fiberglass, high-density foams, machinable epoxy boards or even clay or wood/plaster models often are suitable. Tooling costs and complexity increase as the part performance requirements and the number of parts to be produced increase.

New tooling paste enables complex pattern manufacture
12/2/2008

FRP forms enable fluted concrete column design
10/6/2008

 The Century Project, a 42-story luxury condominium tower in Los Angeles, Calif. , designed by Robert A. M.

New metal coating to optimize composite tooling
5/1/2008

Near the end of its development cycle, this nanostructured metal overlay promises to extend the working life and improve the cost-effectiveness of carbon/epoxy tooling.

Tooling Update: New dimensions in tooling
1/1/2008

Nanoenhancements, out-of-autoclave strategies and low-pressure RTM headline efforts to increase mold quality and productivity and cut tool cost.

JEC COMPOSITES 2007 Highlights
5/1/2007

Advanced composites make notable marks not only in traditional aerospace apps, but in automotive, sport and infrastructure arenas as well.

Inside Manufacturing: A Reinforced Thermoplastic Car Hood?
2/1/2007

Low-density GMT-cored sandwich construction and novel inductive mold-heating strategy are a viable option for horizontal body panels.

Composite Spoilers Brake Airbus For Landing
7/1/2006

New RTM'd carbon composite center hinge fitting withstands 20-ton air load in commercial jet spoiler assembly.

« Prev | Page 1 of 5 | Next »

RSS